The New AC2000

Statech Repair

Out with the Old.......................In with the New!

The AC2000 is an all new drop-in replacement for your EMS1000 or EMS1000A HVAC system controller. It works better than the original! Some of the features that the AC2000 offers:

• Replaces the electronics of the Sta-tech EMS 1000 Controller.
• 100% compatible - no need to replace dampers/sensors or rewire.
• Time is kept even the power is interrupted for 12 hours.
• All settings are stored in permanent memory.
• New modern Faceplate
• Same size as original - fills the opening in the wall.
• Easily programmed on site to fit your home.
• Supports one or two stage furnace and A/C.
• 4 setback times.
• Advanced signal processing.
• Up to 8 zones.
• Much more accurate, balanced Temperature measurement
• Tolerates sensor errors.
• Friendly 80 Character Display.
• Reports problems to the user in English.
• Far fewer components for higher reliability.
• 1 year warranty

We will come to your house and perform the following:

• Remove the EMS 100 and install/configure the AC2000.
• Run full diagnostic on the entire system.
• Check Temperature Sensors (new Sensors are additional cost).
• Check for any wiring mistakes, additions, etc.
• Give you a map of the zones.
• Give you written and verbal instruction on the use of the AC2000.
• Make adjustment for additions or remodeling.

OtherNew Replacement Products

Call for an appointment today!
(925) 699-4708